Hi guys, I have a new amp, this is a blackstar ht stage 100 and I want to use its power stage with the eleven rack, that amp head is connected to a 2x12 mesa boogie cabinet, I connected the guitar to the eleven rack guitar input, then, the output to amp (1 left) to the return input of the back on my amp head, and that should do the work, but no sounds coming from anywhere, I might be passing something but not sure what, any idea guys?

Thanks!

Do you hear anything if you plug some headphones into the headphone out of the 11r? Does it make sound if you run a cable from the xlr into the guitar amp (if you have an xlr to 1/4" adapter)?

Hi Downrazor11, thanks for your reply, yes, checking as you suggested with headphones and it does work, I mean, I can listen everything there, didn't check with the XLR to 1/4 cable but I assume is going to work as well, the thing is, why it sounds with the headphones and not with my setup? You think it is something faulty at any point on my rig?

Thanks so much!!

A polite bump, have a good night guys!

You've got to check the value of the "output to amp 1" parameter. If you want to send to the amp the entire rig minus the cab the right value is "rig out no cab".

Thank you, and yes, that's what I'm doing, I'm not sure if there's something else I should be doing in the settings on the 11R? heres a few pics:





Thanks a lot for the help guys!

Arturo

Everything seems ok to me.
Can you check in the patch that you are using which value the "to OUT 1" parameter has in the "OUTPUT" section (editing from the 11R itself)?

Sure, this is what I got



Thanks

Very strange.
Everything ok here too.
Just for the sake of it:
1. Guitar and amp only: there's sound?
2. Standby is off on the amp?
3. Did you try a mono patch?
4. The effects loop of the amp is at -10dbV?
5. You can get signal out of the emulated output?

Hi there Ichil, good morning, thanks for the reply, ok, let's check:

1. Guitar and amp only: there's sound?
Yes, actually, I have a few analog pedals running thru the loop of the amp and that works great, so, it's not the amp with a faulty return jack input or something.

2. Standby is off on the amp?
Yes, the way it should be

3. Did you try a mono patch?
4. The effects loop of the amp is at -10dbV?
5. You can get signal out of the emulated output?

Those last 3, do you mind to guide me on that? I mean, I don't know how to try a mono amp or how to get a signal out of the emulated output.

Thanks so much!