FCB1010 Question

FCB1010 Question - 09/10/16 03:06 PM

Hi all; have programmed my stock FCB1010 so 1-5 are 'presets' (Rhythm, lead, clean etc) and 6-10 are 'pedals' (tuner, chorus, phaser etc) and all has been working well, except the split second of audio cutout is now bothering me between preset changes.

How do I program a single button to turn on multiple pedals? That way I can turn on an EQ, delay and reverb for a solo boost and all my troubles will be gone!

Posted by: jaminjimlp

Re: FCB1010 Question - 09/13/16 12:52 AM

don't think it is possible

Posted by: mojah

Re: FCB1010 Question - 09/27/16 12:45 PM

I know with the UNO eprom you can toggle 2 CC's when selecting a patch. The newer stock eproms have some of the uno stuff not sure how much. I used to do this for a lead boost for a while before I went back to a stand alone wha pedal. Now I use the two pedals on the FCB. One controls delay mix the other gain/volume. Just program the initial patch with the two things (CC's)off then hit the same pedal again and they turn on, once more to turn them off. There is no delay. You can program any cc's you wish per patch that way but only two.