Posted by: rjw
stereo setup questions - 09/10/15 12:41 AM
Hi
I would like to use my 11r to send sound to 2 amps with a slight delay to the 2nd amp, in an attempt to get a fatter and possibly different sound out of each amp.
I've done this with Cubase (alone, w/git plugged straight into a ur44)
I am looking for best results options
Thanks
Posted by: jaminjimlp
Re: stereo setup questions - 09/10/15 12:28 PM
I would say try to put your stereo chorus at the end of the fx chain and then just plug the 1/4" "out to amp" connections to each amp... then you can mess with the rig output setting as well to see what sounds best.
Posted by: rjw
Re: stereo setup questions - 09/10/15 11:42 PM
Thanks, I'll give that a shot
Posted by: rjw
Re: stereo setup questions - 09/19/15 01:57 PM
the chorus is not quite what I want
any other options?
I just want stereo out with a single delay on one channel 10 to 30ms
Posted by: rjw
Re: stereo setup questions - 09/20/15 09:31 AM
Having good success using the dyn delay...set repeat to 1 and short delay time and delay at end of chain
anyone try this ?
if so what other settings did you use.
I'll post a picture of my settings when I have it tweaked. at the moment it is sounding good, but I'm still tweaking
just saved myself the cost of a pedal!!